Additional information | 16 |
Message | Explanation/Action |
|
|
•The HDD has not been sufficiently optimized. Please optimize again.
If this message appears repeatedly after optimizing the HDD it is likely that there is not enough free space on the HDD for optimization to complete properly. Please erase some titles from the HDD and optimize again.
•An error occurred. Please consult the service center. Note that contents on the HDD may be erased when servicing this unit.
This message is displayed when information from the HDD cannot be read. The HDD may be damaged or broken. Please ask your nearest
•The Hard Disk Drive info is incorrect. Use the Disc Setup menu to reinitialize.
As the HDD info cannot be properly read, no new recordings can be made. Reinitializing the HDD (page 133) may result in your being able to make recording again. Note that reinitializing the HDD will erase all recorded contents, including protected files.
•This signal’s TV system is different from the The TV system (PAL, NTSC, etc.) of the current channel is different
recorder’s setting. | from the TV system settings of this recorder. |
|
|
• Recording failed due to a TV system | The timer recording failed because the TV system of the channel set |
mismatch. Press DISPLAY to clear message. | for recording was different from the setting of the recorder. |
•Playback has stopped because the TV system During recording or timer recording standby, the TV System (PAL,
is different than the recording. | NTSC, etc.) of the playback video changed, causing playback to stop |
| automatically. |
•You are not allowed to watch this Conditional Access Programme.
A CA module or smart card (obtained from your service provider) is required to watch the selected programme. Insert the supplied module or card into the Common Interface card slot on the front panel of the recorder (page 17).
•There is no DV input or the input signal is No signal was detected at the DV IN jack. This may appear if a blank
unrecordable. | section of DV tape is playing in the connected camcorder. |
|
|
• No DV camcorder connected. | The camcorder is not connected properly, or the camcorder is |
| switched off. |
•You cannot connect more than one DV camcorder at a time.
This recorder’s DV jack supports connection to just one camcorder.
• Cannot operate the DV camcorder.
This recorder cannot operate the DV camcorder. Try switching off the camcorder then turn it back on again.
•Could not operate the DV camcorder. This recorder was not able to operate the DV camcorder.
•The DV camcorder is not set for playback. The camcorder is in camera mode. Switch it to playback mode.
Please select playback mode on the DV camcorder.
•The printer is not ready or is not connected. Please check the printer.
This message is displayed when communication could not be established with the printer. See the Troubleshooting section if you do not know the cause.
•Printing has been cancelled because ... This message is displayed when there is a printer error during printing. After checking the printer for the cause of the error, either reconnect the printer and start the printing job again, or select “Yes” to resume printing (select “No” to cancel the print job). See also the operating instructions that came with your printer for possible causes of print errors.
157
En