Pioneer VSX-D2011-G Opening the Front Panel, Operating range of remote control unit, press the

Before You Start

Operating range of remote control unit

The area in which you can use the remote control to operate the VSX-D2011 is fairly large. To use, point the remote control toward the remote sensor on the front panel of this unit while within the range shown below.

Remote control may not function properly if:

•There are obstacles between the remote control and the remote sensor.

•Direct sunlight or fluorescent light is shining onto the remote sensor.

•The receiver located near a device emitting infrared rays.

•Operated simultaneously with another remote control which uses infrared rays.

30

30

7m

Installing the Receiver

CAUTION!

•Do not cover this unit in any way, for exam- ple with a sheet or piece of cloth. This would prevent proper heat dispersal.

• Do not any place object directly on top of this unit. This also would prevent proper heat dispersal.

Opening the Front Panel

To open the front panel push gently on the lower third of the panel with your finger.

Switching video system between PAL and NTSC (if necessary)

This receiver is able to use two types of video systems for its OSD (on screen display) either PAL or NTSC. If you don't match the system on the amplifier with your home system no OSD will appear on your TV. The default setting is PAL. If you use this system you don't need to make any settings here. People with multi-system TVs don’t need to worry about changing the setting either. If necessary, follow the instructions below to switch the type of video system.

							1	Put the receiver in the STANDBY mode.
STANDBY/ON
		STANDBY					2 While holding down the TONE + button
MOVIE	MUSIC	ENTER
MULTI JOG		SET UP	RETURN SELECT HI-SAMPLING	MODE	BAND	CLASS	SELECT	press the	STANDBY/ON button.
		MULTI JOG CONTROL SIGNAL HI-BIT		SB CH			STATION TU
		PHONES	TONE CONTROL			SETUP		The video system type will change depending on the state
			SPEAKERS TONE BASS/TREBLE			MIC
							DIGITAL IN	the receiver was previously in. The new type, either PAL or
								NTSC, will appear in the display. It will be shown for about
								seven seconds and then the receiver returns to normal
								operating mode.

8 2 2 To change the video system type again repeat steps 1 and 2.

En