Pioneer VSX-D2011-G, VSX-D2011-S manual Connecting Analog Audio Components, Audio cords, Turntable

Connecting Your Equipment

Connecting Analog Audio Components

Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet.

Connect your audio components to the jacks as shown below. These are all analog connections and your analog audio components (turntable, cassette deck) use these jacks. Remember that for components you want to record with you need to hook up four plugs (a set of stereo ins and a set of stereo outs), but for components that only play (like a turntable) you only need to hook up one set of stereo plugs (two plugs). If you want to record to/from digital components (like a CD-R) to/from analog components you must hook up your digital equipment with these analog connections.

*The arrows indicate the direction of the audio signal.

									ANALOG
									OUTPUT
PCM/		FM UNBAL 75Ω					PRE OUT		L
2DIGITAL /	ANTENNA		AM LOOP
DTS/MPEG
							SUB
									R
	IN					CENTER	WOOFER
OUT1
		CONTROL
			MONITOR OUT 2						CD player
	OUT
OUT2						FRONT
	R	L	MONITOR OUT 1				L
IN 1						R
	PLAY
						SUR-		ANALOG
(TV/
SAT)	IN			IN		ROUND		OUTPUT	INPUT
						R	L	(PLAY)	(REC)
IN 2	CD-R/			VCR1/
(CD-R/	TAPE1			DVR		SUR-	(Single)	L	L
TAPE1)	OUT			OUT		ROUND
						BACK
	REC					R	L
								R	R
IN 3	PLAY					FRONT
(DVD/	IN			IN		SUR-	L		Recorder 1 (CD-R/TAPE)
IN 4	TAPE2
LD)	MD/			VCR2		R
(CD)	OUT			OUT		ROUND
	REC					R	L
	CD			TV/		SUB	CEN-
	IN			SAT		WOOF-	TER	ANALOG
ASSIGNABLE				IN		ER		OUTPUT	INPUT
								(PLAY)	(REC)
	PHONO/			DVD/		SUR-
USB	LINE			LD		ROUND		L	L
	IN					BACK
				IN
AUDIO						R	L
	R	L	R	L
					VIDEO	S VIDEO		R	R
DIGITAL		AUDIO	AUDIO		VIDEO		MULTI CH IN
									Recorder 2 (MD/TAPE)

7Audio cords

Use (RCA) audio cords (not supplied) to con- nect the audio components.

L	Connect red plugs to
	R (right) and white
	plugs to L (left).
R	Be sure to insert
	completely.

Turntable

If your turntable has a ground wire, connect it to the signal ground terminal (H).

memo • If you want to hook up any equipment other than a turntable to the PHONO/LINE jack please go to the PHONO/LINE Setup (see page 94) and choose the LINE setting. If your

turntable has a phono pre-amplifier (most do not) please choose the LINE setting as well.

•Depending on where the cassette deck is placed, noise may occur during playback of your cassette deck which is caused by leakage flux from the transformer in the receiver. If you experience noise, move the cassette deck farther away from the receiver.

20

En