REMOTE CONTROL OPERATION
PUTTING BATTERIES INTO THE REMOTE CONTROL UNIT
+ | – | + |
| ||
| – | |
|
|
1.Open the battery compartment cover on the rear of the remote control unit. The cover should open easily if you slide it in the direction of the arrow while pressing on it with your thumb.
2.Press the RESET button in the center hole of the battery compartment.
3.Take out the two supplied batteries size “AA” (IEC R6P), and insert them into the battery compartment in accordance with the indications in the compartment.
4.Close the cover of the battery compartment.
Incorrect use of batteries may lead to leakage or rupture. Always be sure to follow these guidelines:
A:
Always insert batteries into the battery compartment correctly matching the positive ª and negative · polarities, as indicated inside the compartment.
B:
Never mix new and used batteries.
C:
Batteries of the same size may have different voltages, depending on their type. Do not mix different types of batteries.
REMOTE CONTROL RANGE
30° 
30°
7m (23 feet)
When operating the remote control unit, point the front of the unit at the front panel of the receiver. The remote control unit may be used within a range of about 7 meters (23 feet) from the remote sensor, within angles of up to about 30 degrees.
Performance of the remote control unit is adversely affected in the presence of a strong fluorescent light. Keep such lights away, especially from the sensor window.
Battery Replacement
As battery power runs down, the range over which the remote control unit can operate decreases. Also, ONE TOUCH OPERATION and other buttons light less brightly.
When the range becomes too short, change the batteries.
20
<ARB7050>
