VIDEO RECORDING
Refer to the connection procedures on pages 8 to 10 and refer to the VCR’s Operating Instructions regarding proper operation procedures. Recording can be performed on both VCR 1 and VCR 2.
1
1.Select the source you want to record from with the input selector buttons.
÷When recording from a LaserDisc on VCR 1 or VCR 2 = LD
÷When recording from the TV tuner on VCR 1 or VCR 2
=TV/SAT
÷When recording from VCR 1 on VCR 2 = VCR 1
÷When recording from VCR 2 on VCR 1 = VCR 2
÷When recording on VCR 1 or VCR 2 from a component connected to the front panel VIDEO INPUT jacks = VIDEO
2.Start recording on the VCR.
For VCR, select a line input (external input).
3.Start playback on the component selected with the input selector buttons.
The volume, balance and tone controls have no effect on the recording.
NOTE:
When recording with VCR 1, be sure the input selector is set to a position other than VCR 1. When recording with VCR 2, be sure the input selector is set to a position other than VCR 2.
GUI operation enables easy copying from a LaserDisc to VCR 1 (or 2), and copying between VCR 1 and VCR 2. (Refer to page 28.)
SURROUND EFFECT
1
1.Select the desired mode with the DOLBY
The DSP MODE changes in sequence each time the DSP MODE button is pressed. (The DSP MODE indicator lights.)
3 JAZZ | 3 DANCE | 3 HALL |
|
off 2 | THEATER 2 | SIMULATED | 2 |
|
| SURROUND |
|
÷Press the DSP OFF button to switch the DSP off.
÷If rear speakers are not selected during SPEAKER MODE setting (page 29), pressing the DOLBY
2.Adjust levels to achieve a correct surround sound reproduction.
This is done using GUI (page 24). For details concerning how to perform level adjustment, refer to page 30.
You can set this unit to match the requirements and specifications of your stereo system’s speakers (whether or not center speaker(s), rear speakers or a
NOTE:
This unit does not feature conventional switching between NORMAL/ WIDE / PHANTOM center modes.
19
<ARB7050>
