|
| TROUBLESHOOTING |
|
|
|
Symptom | Cause | Remedy |
|
|
|
No auto stop. | ÷ Input signals are not strong enough. | ÷ (FM) If the supplied simple antenna is being |
|
| used, change to an outdoor antenna. |
|
|
|
TV source cannot be seen when | ÷ TV antenna is not connected to the VCR, or | ÷ Consult the VCR’s operating instructions, and |
the VCR’s TV tuner is used. | connections are faulty. | connect the antenna correctly. |
| ÷ The VCR’s input switch is set to line input. | ÷ Set the VCR’s input switch to |
|
|
|
No rear sound is produced. | ÷ The SPEAKER MODE is set incorrectly. | ÷ Set correctly. |
| ÷ The REAR LEVEL is turned down. | ÷ Refer to page 30 and adjust the rear level. |
| ÷ Speaker connecting wires are disconnected | ÷ Connect wires to the terminals securely. |
| from the REAR SPEAKERS terminals. |
|
|
|
|
Remote control does not work. | ÷ Batteries are dead or missing in remote | ÷ Insert new batteries. |
| control unit. |
|
| ÷ Poor angle or too great a distance from the | ÷ Use within 7 meters and within a 30 degree angle |
| remote sensor window. | of the remote sensor window. |
| ÷ There is an obstacle between you and the | ÷ Change your position or move the obstacle. |
| remote sensor window. |
|
| ÷ A fluorescent light is shining on the remote | ÷ Move the receiver so fluorescent light does not |
| sensor window. | shine directly on the receiver’s front panel remote |
|
| sensor window. |
| ÷ The | ÷ Try changing the position of this unit or other |
| other components. | units. If the signal still does not reach other |
|
| components, use a supplied |
|
|
|
Abnormal functioning of this unit may be caused by static electricity or other external interference. To restore normal operation, turn the power off and then on again, or unplug the AC power cord and then plug it in again.
35
<ARB7050>