Pitco Frialator L22-355 Hold Pre-Alarm, Spin Time, Spin Rate, To Exit Level 1 programming

Spin Fryer I12 Cooking Computer

Pitco P/N 60149505

2.2.4Hold Pre-Alarm

Hold Pre-Alarm is a timer setting that is used to warn operators that the Hold Time is about to expire. To use Hold Pre-Alarm, the time value must be a non-zero value, and, must be set to a value less than Hold Time. Default value is zero, meaning the Hold Pre-Alarm is inactive.

Display shows [nPA mm:ss] [TIME] where “n” is the key number, PA means Pre-Alarm, and “mm:ss” is minutes and seconds.

Use the product keys for numeric entry to adjust the current setting. Press the key to save pre-alarm time. Note: Value entered for hold pre-alarm time is the time from the end of the hold period.

2.2.5Spin Time

Spin time is the duration that the basket will spin after the cook cycle. The basket will not spin after a cook cycle if the set spin time is set to 0.

Display shows [nST mm:ss] [TIME] where “n” is the key number, ST means Spin Time, and “mm:ss” is minutes and seconds.

Use the product keys for numeric entry to adjust the current setting. Press the key to save spin time.

2.2.6Spin Rate

Spin rate is the maximum speed the basket will spin after the cook cycle. The spin rate value must be between 200 and 500.

Display shows [nSR XXX] [TIME] where “n” is the key number, SR means Spin Rate, and “XXX” is the rate in RPMs.

Use the product keys for numeric entry to adjust the current setting. Press the key to save spin rate.

Display will again return to . Repeat steps from section

2.2.2to make changes to any other product keys or continue.

2.3To Exit Level 1 programming:

Display shows .

Press the key. Display shows . Continue to section 3 “To Change Options”, or, exit here in the next step.

To exit Level 1 programming, press the key again.

Displays will show are running.

;

, or

, when no active cooks

Page 9 of 28 L22-355 Rev 1