LCD Monitor Instructions
Adjustment Procedure
Before Adjustment
The signal timing for a computer which this LCD monitor supports is listed in "Table of Preset Data" on Page 55, the recommended value of Vertical Frequency for this model is 60Hz. (Unlike CRT Monitors, the display becomes stable when Vertical Frequency is low.) It is recommend to set Vertical Frequency of a computer connected at 60Hz by "refresh rate setting" before starting adjustment procedure.
1Display the Windows or other screen
After a computer is connected with this LCD Monitor, activate a computer and then shows a bright screen on this LCD Monitor. It might not be possible to adjust the screen correctly for a dark screen.
For DOS mode, run an application that shows the edges of the screen (edit etc.) to adjust screen.
2Display the OSD (On Screen Display) Menu
Press the [MENU] button to display the following menu.
|
| brightness | 50 | - | + | |
| picture | contrast | 50 | - | + | |
| advanced | H position | 50 | - | + | |
(Ex.) | pip | V position | 50 | - | + | |
adv pip | phase | 15 | - | + | ||
| ||||||
| options | frequency | 1056 - | + | ||
| utilities | scaling |
|
| Wide | |
|
|
|
|
Main menu | Sub menu |
|
¥To leave the Main menu, press the [MENU] button again.
15