Polaroid Polaview 305 manual Plug the power cord into the power-cord receptacle

Detailed setup 21

Turning on the projector

The power switch

The projector and the external monitor (should you use one) should be turned on before you turn on your computer. This ensures that the computer properly senses the display dur- ing the start-up process.

On the rear panel of the projector there is a power-cord receptacle and a power switch.

Power-cord receptacle

Power switch

To turn on	1	Plug the power cord into the power-cord receptacle.
the projector	2 Plug the other end of the power cord into a properly
		grounded electrical outlet.
	3	Move the power switch to the “on” position.
	4	Press the key to turn on the lamp. The lamp ignites slowly.
	5	If you have not already done so, connect the projector to
		your computer and external monitor (if you use one).
	6	Turn on your computer and external monitor (if you use one).
		You should see a projected image of your computer screen.

Note: The projector consumes 800 watts of power. Most circuits surge protectors support 1,200 watts. Be sure to connect any peripheral equipment to a separate circuit or surge protector.