Polaroid Polaview 305 manual Turning the lamp on and off The key, Clear

Detailed setup 39

Turning the lamp on and off

The key

The lamp is off when you first turn on the projector. Press the key (shaded gray in the illustration below) on the remote control or control panel to turn the lamp on. The green power-indicator light illuminates. It takes a few sec- onds for the lamp to warm up.

MUTE

—VOLUME +

MENU

MENU

SOURCE	SETUP	SETUP
PROG 1	PROG 2
		CLEAR
	SCALE	SOURCE

To turn the lamp off, press and hold the key for about two seconds. When you turn the lamp off, the projector fans continue to run for about two minutes. Allow the fans to run until they automatically turn off. This lengthens the lamp life and helps ensure that the projector cools properly. Turning the lamp off does not turn off the projector. To turn the power off, move the power switch on the back of the projec- tor to the “off” position.

After you turn off the lamp, you can immediately turn it back on within five seconds. If you wait longer than five seconds, you must then wait 90 seconds before turning it back on.

This is a built-in safety feature that helps prevent damage to the lamp. Press the key again to turn on the lamp once more. The lamp illuminates slowly, to prolong lamp life.