Polaroid Polaview 305 manual Introduction, DEC workstations, Connecting, video and audio

10Introduction

DEC workstations

1Disconnect your computer-to-monitor cable at the comput- er end.

2Connect the free end of the monitor cable to the DEC 3C3-to- LCD adapter (part number C946).

3Connect the free end of the DEC 3C3-to-LCD adapter to the projector COMPUTER OUT connector.

4Use the DEC 3C3-to-LCD connector cable (part number C946-6) to link the projector to the computer. Connect the end marked LCD to the projector COMPUTER IN connector, and the end marked COMPUTER to the workstation video- output connector.

	Proceed to the next section, Connecting video and audio.
Connecting	Connect audio and video sources to the projector, using this
video and audio	table as a guide. If you need more information, see the
	appropriate section in Chapter 2, Detailed setup.
To set this up:	Connect this cable:	From here:	To here:
Video from	Composite	VIDEO 1, 2	RCA port on
VCR/ laserdisc	audio/video	ports on	VCR marked
	cable (C497-6)	projector	VIDEO OUT
			or some-
			thing similar
Video from	S-video cable	S-VIDEO 1, 2	VIDEO OUT
S-video	(C466-6)	ports on	port on
device		projector	S-video
			device
Audio from	Composite	AUDIO IN 1, 2	AUDIO OUT
VCR/laserdisc	audio/video	ports on projector	port on VCR
	cable	(red = right,	(red = right,
	(C497-6)	white = left)	white = left)
Audio from	Computer	Left/right	AUDIO OUT
computer	audio	COMPUTER	port of the
	cable	AUDIO IN ports	Mac or the
	(C498-6)	on projector	sound card
			of a PC