If you want to revert to the original factory settings for a

Using the projector 51

Reverting to the

If you want to revert to the original factory settings for a

factory defaults

specific computer source, choose Image, Factory Defaults,

 

Reset.

 

To reset the projector itself, press the CLEAR key, then press

 

each of the four arrow keys on the projector control panel

 

once. The power LED indicator blinks twice to indicate the

 

projector has been reset.

Adjusting the image

 

Press the SETUP key to gain access to most of the settings

 

you need to adjust the image.

 

Note: The choices on the Setup menu vary, depending on

 

your current input source.

Adjusting the

To adjust the brightness, press the SETUP key until the

brightness

Brightness slider appears. Press the edges of the

 

MouseDisk, use the optional Cyclops wand or laser pointer,

 

or press the left and right arrow keys to move the slider.

 

You can also adjust the brightness by opening the projector

 

menus and choosing Bright from the Image menu.

Adjusting the

To adjust the contrast, press the SETUP key until the

contrast

Contrast slider appears. Press the edges of the MouseDisk,

 

use the optional Cyclops wand or laser pointer, or press the

 

left and right arrow keys to move the slider.

 

You can also adjust the contrast by opening the projector

 

menus and choosing Contrast from the Image menu.

Correcting shimmering

If your projected image has horizontal streaks, or seems to

or streaks

shimmer slightly, adjust the Sync setting. (This setting is

 

only active when the source is your computer.)

 

Press the SETUP key until the Sync slider appears. Press the

 

edges of the MouseDisk, use the optional Cyclops wand or

 

laser pointer, or press the left and right arrow keys to move

 

the slider. Repeat until the streaks disappear.

Page 55
Image 55
Polaroid Polaview 305 manual Adjusting the image, If you want to revert to the original factory settings for a