Using the Polycom PowerCam Presenter

Keep in mind that the Tight Tight, Wide Wide, Left Left, and Right Right button settings described here are merely guidelines, and that you can set and change the settings to best suit your needs. For more information, refer to Setting and Using Presenter Views on page 2-12.

When the message Remote control batteries are low appears on the screen, you need to replace the batteries.

Configuring User Settings

The Menu button on the remote control gives you access to the user settings. These settings enable you to configure and calibrate the camera, set LAN properties, and specify video output settings.

Configuring Camera Settings

The Camera Settings screen lets you specify the settings for the input signal, backlight compensation, camera direction, and the camera tracking area.

Configuring Input Signal, Camera Direction, and Backlight Compensation

You may need to set or change these camera settings depending on your preferences and on the environment in which you use your PowerCam Presenter.

To configure the settings for input signal, camera direction, and backlight compensation:

1.Press Menu on the remote control.

2.Select Camera Settings from the PowerCam Presenter screen.

3.Configure these settings:

Setting

Description

 

 

Input Signal

Specifies your camera’s input signal:

 

Select S-Videoif you connect your camera to the

 

PowerCam Presenter controller using the

 

S-video connector on the camera.

 

Select Composite if you connect your camera to

 

the PowerCam Presenter controller using the

 

composite connector on the camera.

 

 

2 - 3

Page 15
Image 15
Polycom 3725-24004-001/A manual Configuring User Settings, Configuring Camera Settings, Setting Description Input Signal