Hold the display console above the upright supports, and then plug the cable connector into its receptacle. Push excess cable into the upright support.
Avoid dropping the display cable inside the upright support.
(D), two washers (B), and two locknuts (C). Finger tighten.
Be careful not to pinch the display cable. Make sure that the heads of both bolts are on the underside of the clamp as shown.
Install the right and left handrails. Insert the base of the handrail first, and then rest the top section on the handrail clamp. The foam grip should touch the handrail clamp base.
CAUTION: Attach one handrail at a time. Hold the handrail until it is securely seated in the handrail clamp. If you do not, the handrail can rotate and cause damage to the unit or injury to yourself or others.
Attach the handrail clamp cover using two carriage bolts (E). Apply pressure to the clamp cover while you thread a washer
(B) and locknut (C) onto each bolt. Finger tighten.
Secure the lower portion of the handrails using four
Return to the upright support clamp and wrench tighten the fasteners using a ⁹⁄₁₆
Wrench tighten the handrail clamp fasteners.
