Checking the Alignment of the Running Belt
The belt is aligned at the factory before shipment. However, during shipment or by using the treadmill on an uneven surface, the belt might move off center. Proper belt alignment is important because it allows the belt to remain centered and assures smooth operation.
Follow these steps to check the alignment:
CAUTION: Do not walk on the running belt during this procedure.
1.Locate the ON/OFF power switch at the front of the black hood and turn ON the treadmill.
2.Stand next to the treadmill. and answer the startup questions. Select “Manual” mode.
3.Continue to stand next to the treadmill and increase the running belt speed to 6 miles per hour using the SPEED 
arrow key.
4.Walk to the back of the treadmill and observe the belt as it runs (watch for about one minute).
If the running belt | Then... |
tracks centered on the treadmill | the belt is functioning correctly and |
| no adjustment is necessary |
|
|
runs or drifts off center | you need to adjust the belt; see |
| Aligning the Running Belt at the |
| end of this manual for instructions |
Important: If you notice that the belt needs alignment, make the adjust- ments at once. Failure to do so might cause the belt to tear or fray which is not covered by warranty.
5.Press and hold STOP to stop the running belt. Using the ON/OFF switch, turn OFF the treadmill.
If the belt is functioning correctly, the M9.5sp Programmable Treadmill Ergome- ter is assembled and ready to use. If the belt needs alignment, refer to Aligning the Running Belt for instructions before using the treadmill.
page 11
