Precor 9.5sp Photo, Secure top two, bolts, Lift motor, Treadmill motor, Plug lift-motor, board

Photo 3	Secure top two
	bolts.
Lift motor
Treadmill motor

Lift motor support mount

	7.	Slide the lift motor into position, shaft side down, with the long tube toward
		the front of the treadmill and the short tube facing the treadmill motor. (See
		Photo 3.)
	8.	Secure the lift motor by placing one of the two hex-head shoulder bolts on
		the 5/16" hex wrench (both are found in the hardware kit). Insert the bolt
		through the lift motor mount and into the lift motor. Follow the same proce-
		dure for the second shoulder bolt. (See Photo 3.) Align the motor and
		securely tighten the shoulder bolts.
	9.	Locate the two plastic plug caps in the hardware kit. Insert the plastic plug
		caps over the two shoulder bolts on the lift motor support mount.
Photo 4	Plug lift-motor
	wiring harness
	into printed circuit
	board.

Lift-motor wiring harness receptacle

Printed circuit board

Lower board chassis

10.Plug the lift-motor wiring harness into the receptacle on the printed circuit board. (See Photo 4.)

11.Using the cable ties supplied in the hardware kit, secure the lift-motor wiring to the lower board chassis. Cut the ends of the cable ties so the excess plastic does not interfere with the motor or circuit board.

page 9