5

Maintaining the M9.5sp Treadmill

 

 

Cleaning the Treadmill

 

The M9.5sp Programmable Treadmill Ergometer requires little maintenance to

 

keep it running smoothly and efficiently. Typical maintenance tasks include

 

cleaning the treadmill and aligning the running belt. Instructions for both

 

procedures are provided in this section.

 

Cleaning the Treadmill

 

Your Precor treadmill relies on low friction for efficient operation. To keep the

 

friction low, the treadmill must be as clean as possible.

 

CAUTION: Turn OFF the treadmill and disconnect the power cord before

 

cleaning.

 

Before a workout, use a damp, soft cloth to clean the staging platform, running

 

bed, and between the belt and running bed surface as far as you can easily

 

reach. This removes any dirt or dust which might affect the smooth operation of

 

the treadmill.

 

Vacuum underneath the unit every week to prevent the accumulation of dust

 

and dirt on the running belt.

 

Periodically, clean the treadmill’s frame, control panel assembly, and running

 

belt. Use mild soap and water for this. To clean the running belt, use a soft

 

nylon scrub brush. Never pour water or spray liquids on the control panel. Allow

 

the treadmill to dry completely before using.

 

Aligning the Running Belt

 

The correct alignment of the running belt is critical to the smooth operation of

 

the treadmill. The belt is properly aligned at the factory. However, during

 

shipping and handling or by use on an uneven surface, the belt may move off

 

center and require a few simple adjustments.

 

Before adjusting the running belt, check its operation by following the steps in

 

Checking the Alignment of the Running Belt earlier in this manual. If you

 

determine that the belt needs adjustment, follow the instructions here.

 

CAUTION: To avoid injury, special care must be taken when adjusting the

 

running belt. Turn OFF the treadmill and wait for the running belt to come

 

to a complete stop before adjusting or working near the rear roller.

 

Remove any loose clothing and tie back your hair. Be very careful to keep

 

your fingers or any other object clear of the belt and rollers. The treadmill

 

will not stop immediately if any object becomes caught in the belt or

 

rollers.

page 25

Page 25
Image 25
Precor owner manual Maintaining the M9.5sp Treadmill, Cleaning the Treadmill, Aligning the Running Belt, Rollers