TOC | INDEX |
D. USING KIOSK MODE
Kiosk Mode allows you to use both of Printer's Bins as input, doubling your disc capacity from 50 discs to 100 discs. In this mode, the finished discs will be deposited out through the front "reject area" of the Printer. In Kiosk mode all discs would be ejected in this manner. Rejects can be identified in the stack because they will not be printed in the same manner as successfully recorded discs. Refer to the Kiosk Kit installation instructions below.
•Attach the Output Bin Holder as shown, aligning the Locating
Tabs on the Output |
| |
Bin Holder with the |
| |
Slots located on the | Slots | |
underside of the | ||
| ||
Printer allowing the |
| |
holder to hang off the |
| |
edge of the table. |
| |
Notice the slots do |
| |
allow for adjusting |
| |
the position of the |
| |
output bin. If your |
| |
discs are not falling | Locating Tabs | |
into the bin, you will | ||
be able to move the |
| |
bin slightly to align it. |
|
•Place the Output Bin on the Output Bin
Holder as shown.
