USING THE OPTIONAL SETUP
MODULE
Introduction
The optional Setup Module is a small cartridge that plugs directly into the
Setup Module Installation
To install the Setup Module, perform the following steps.
1.Turn off power to the printer.
2.Disconnect the cable plugged into the serial port if one is present.
3.Plug the Setup Module into the serial port.
4.If a cable was present in step 2, reconnect it to the connector on the rear of the Setup Module.
5.Turn on power to the printer.
6.If this is not the first time the Setup Module has been connected to a printer, the printer will proceed with step 7.
If this is the first time the Setup Module has ever been attached to a printer, the printer will temporarily display the following message and
74
