Printek 850 Series manual Loading Paper, PrintMaster 850/850si Single Tractor Model

G E T T I N G S T A R T E D

Loading Paper

When shipped from the factory, the basic configuration for all ten forms is an eleven-inch form, six lines per inch, and ten characters per inch. If the forms you are loading do not match these requirements, please refer to the printer Configuration” chapter on page 34 and review the “Introduction To Setup” and “Forms Menu” sections.

Please refer to the appropriate section below for loading paper in the PrintMaster 850/850si, or PrintMaster 852si.

PrintMaster 850/850si Single Tractor Model

Loading the Form in the Tractors

1.Open the paper door (rear lid) of the printer. This will provide access to the tractors as shown below.

PrintMaster 850 tractors

2.Open the tractor doors and remove the old form.

3.If the new form is a different width than the previous form, unlock the right tractor and move it to approximately the new position.

Note: The left tractor position is fixed and may not be moved.

1 2