G E T T I N G S T A R T E D
Ethernet Interface Connectors on rear of
printer
Interface Set Up
Depending upon which interface is being used to connect the printer to the host computer, some set up may or may not be required. This is true of the standard parallel, serial, or Ethernet.
The factory default settings for each interface should work well for most installations. However, the following paragraphs provide some basic information about each interface and also refer to the page number in the “Printer Configuration” chapter where all the details for each interface are described. If you need to make changes to the default settings, please refer to “Introduction To Setup” on page 34 for instructions on how to access the printer’s Setup menus.
Once you are comfortable that the interface settings match those required by your computer, proceed to the next section, “Installing a New Ribbon Cartridge” on page 10.
RS-232C Serial Interface
This interface uses a 25 pin “D” connector. The default settings are 9600 baud, 8 data bits, 1 stop bit, and no parity with hardware handshake on pin
11.The default printer emulation is Epson. For a complete description of all the default settings for this interface, refer to page 45.
Parallel Interface
This interface uses the standard 36 pin parallel connector. The default printer emulation is Epson. For a complete description of all the default settings for this interface, refer to page 49.
6
