G E T T I N G S T A R T E D
Note: The left tractor position is not adjustable. If it is necessary to adjust where printing begins, refer to the “Aligning Print” in the “DAILY OPERATION” section of this manual.
5.Now position the paper in the right tractor in the same fashion. If necessary, the position of the right tractor may be adjusted. To do so, move the lever on the side of the tractor down to unlock the tractor and slide the tractor sideways on the shafts
After the paper is placed in the tractor and the tractor door is closed, position the tractor far enough to the right so that there is no buckle in the paper between the two tractors, but not so tight that the holes in the paper are distorted. Lock the tractor in place by returning the lever to the up position.
6.Close the bottom paper door and lower the front of the printer down until it latches in place.
Selecting Which Form to Print
With the printer off line, press the UNLOAD/CHANGE button until the desired form is displayed. To use the bottom path, the word “Bottom” must appear below the form name. If the desired paper path is not shown, refer to the “Tractor Path” topic in the “Forms Menu” section of the “PRINTER CONFIGURATION” chapter. When the desired form and path are displayed, press the LOAD/FEED button. The LOAD/FEED
1 5
