IBM 4682/92 PORT E INTERFACE SELECTION
Scan this label to enable the IBM 468x/9x Port E interface.
IBM INTERFACES
IBM 4682/92 PORT E SETTINGS
Data Format: Send As Code 39 — converts barcode data (UPC/EAN, add- ons, Code 93, Codabar, MSI/Plessey and Code 128) into Code 39 format before sending the data to the host.
These settings are for IBM 4682/92 Port E interface ONLY.
Limit Command Set — is an option that causes the scanner to ignore 'enable scanner' and 'disable scanner' commands sent from the host.
Transmit Unsolicited Status1 — when enabled, this option causes the scanner to transmit a status message to the host upon receipt of a "Set Normal Re- sponse Mode" (SNRM) command, and after scanner transmission of a "Non Sequenced Acknowledge" (NSA) response.
SET -------------------------------------
|
| SEND AS CODE 39 |
|
| DON'T SEND AS CODE 39 |
FORMAT |
| ENABLE LIMIT COMMAND SET |
DATA |
| |
| DISABLE LIMIT COMMAND SET | |
|
| |
|
| TRANSMIT UNSOLICITED STATUS - |
|
|
|
| DON'T TRANSMIT UNSOLICITED STATUS | |
END -------------------------------------
1 For this IBM interface, the setting for Unsolicited Status is normally Disabled.
10 | SP400RF Programming Guide |
