R
7100FP EPA Woodburning Fireplace
B. Baffle Removal and Installation
1.Remove all ash from firebox, and extinguish all hot embers before disposal into a metal container.
2.Remove the baffle protection channel by turning it down and pulling it out of the firebox. See Figure 32.1.
Figure 32.3 Removing Baffle (shown without ceramic blanket)
Figure 32.1 Removing Baffle Protection Channel
3.Remove ceramic blanket from above the baffle.
4.With a 3/16 in. Allen wrench, remove the front manifold tube retainer bolt on the air channel under the end of the front tube. See Figure 32.2.
C. Door and Door Gasket
Periodically check the door gasket for proper seal. As the gasket compresses or “seats” during use, it may become necessary to adjust or tighten the door latch.
To Adjust or Tighten Door Latch
Remove spacing washers shown in Figure 32.4. At least one spacing washer and the black washer must be left in place.
OR
Replace the gasket material. Wear or damage to the gasket material can cause air leakage into the firebox resulting in overfiring and loss of efficiency.
A replacement gasket is available from your dealer.
Figure 32.2 Removing Manifold Tube
NOTE: Soak the bolt with penetrating oil for at least 15 minutes before trying to remove it.
5.To remove manifold tube, slide the tube to one side until one end is out of its hole. Then, while lifting that end of the fiber board baffle, pull tube up over the air channel and out of hole at the other end. It is only necessary to remove the first tube in order to remove the baffle.
6.Slide fiber board baffle forward to front of fireplace and straight out through door. See Figure 32.3.
7.To install the fiber board baffle, repeat steps 2 through 4 in reverse. Be sure the fiber board baffle and ceramic blanket are pushed back fully and the blanket is down and flat.
| Left Door | Hinge Pins & |
| Washers | |
|
| |
Right Door | Locknut |
|
| Locking |
|
| Pin |
|
Latch Cam | Square | Left Handle |
Spacing Washers | Key | Assembly is |
|
| stationary |
| Black Washer |
|
Fiber Handle | DO NOT REMOVE |
|
| Door Handle Shaft |
|
Figure 32.4 Door Handle Assembly |
|
Page 32 | September 7, 2007 |