Quadra-Fire 7100FP-BK-B Accessories, 7100FP EPA Woodburning Fireplace, A. Blower Replacement

R

7100FP EPA Woodburning Fireplace

7 Accessories

A. Blower Replacement

Blower Cord Location

The 7100FP Fireplace comes standard equipped with two blowers, installed at the factory with electric access on the right side of fireplace (as you face it).

CAUTION

Shock Risk

Disconnect power by turning off circuit breaker BEFORE servicing.

Blower Replacement Instructions

1.Remove the brick from the bottom of the fireplace and 3 of the back vertical bricks.

2.Remove the 2 screws from the access panel in the fire- box floor. See Figure 31.1.

3.Pry up the access panel using the screwdriver slot and completely remove the panel.

	Screws
	Screwdriver Slot
Figure 31.1	Accessing Blower Motor

Unplug wire harness before removing fan

Figure 31.2 Blower Motor

3.Connect new blower wires to wire harness.

4.Before installing the blower, make sure the grommets are tightly in place. Insert the right blower and place over the 2 locating pins. Repeat for other blower. Figure 31.3.

Figure 31.3 Installing Blowers

5.Re-install bottom panel or firebox access panel in reverse order as described above.

6 Replace the brick that was removed.

7. Reconnect the power.

Removing the Blower

1.Unplug the wire harness.

2.Lift blower from locating pins and remove. Repeat for second blower if necessary. See Figure 31.2.

September 7, 2007 433-1390D Page 31