Ô NOTES Ô

The scanner receives only the data shown above during on-air programming.

On air programming data is normally transmitted at the race track during races.

Invalid Freq. or Invalid Ch appears if the scanner receives a channel number equal to 0 or frequency data which is out of the range of frequencies the scanner can receive.

Checksum Error appears if the scanner receives a checksum error.

4.Press 1 to send the data to the other unit, or press any other key to cancel the operation.

5.The scanner sends the data. Do not disconnect the PC/IF cable or interrupt power to either scanner while the transfer is taking place.

6.To exit the clone mode, remove the cable.

ON-AIR PROGRAMMING

You can also program your scanner by receiving data transmitted on a frequency your scanner can receive (called on-air programming).

You can use on-air programming to store the following data into the scanner:

Channel number (from 000 to 949)

Frequency (any frequency the scanner can receive)

Car number (from 0 to 999, including 00, 000, 01, and 001)

Channel text tag

Channel lockout setting (ON or OFF)

Channel delay setting (ON or OFF)

CTCSS code (67 Hz – 250.3 Hz)

CTCSS setting (ON or OFF)

58