USING ON-AIR

PROGRAMMING

1.Press and hold FUNC for about 2 seconds. Then press

8 and 4. On Air Program appears on the display.

2.Default receiving frequency is 154.6 MHz. If you want to change the receive frequency, press 2 and enter the frequency, then press ENT.

3.To start on air programming, press 1. Ready to Receive appears on the display.

4.Send the data from the PC.

Start Program and the data being received by the scanner appear in the order they are received.

5.When the scanner successfully receives all data,

All Data Correct XX finished (XX: received correct channel number) appears. If the scanner received an error, the

scanner displays

Success = XX Data Error = YY

(XX: received correct channel

number, YY: received error channel number).

On-Air Programming Specifications

Interface — AFSK (Audio Frequency Shift Keying)

Modulation — MSK (Minimum Shift Keying)

Mark Frequency — 1200 Hz

Space Frequency — 1800 MHz

Ô NOTES Ô

•You cannot use an AM frequency during on-air programming. Do not enter a frequency between 108.000 and 136.9875 MHz in Step 2.

•If the scanner did not receive an end bit from the PC, received data status does not appear.

59