TROUBLESHOOTING
If your scanner is not working as it should, these suggestions might help you eliminate the problem. If the scanner still does not operate properly, take it to your local RadioShack store for assistance.
Problem | Possible Cause | Remedy | |
|
|
| |
|
|
| |
The scanner is | The AC or DC | Be sure the adapter’s | |
totally | adapter is not | barrel plug is fully | |
inoperative | connected | inserted into the jack. | |
|
|
| |
| Dead Batteries | Replace or recharge the | |
|
| batteries. | |
|
|
| |
Poor or no | An antenna is not | Make sure an antenna | |
reception | connected or is | ||
is properly connected to | |||
| connected | ||
| the scanner. | ||
| incorrectly | ||
|
| ||
| Programmed | Avoid programming | |
| frequencies listed under | ||
| frequencies are the | ||
| same as “birdie | “Birdie Frequencies” on | |
| Page 60, or listen to | ||
| frequencies. | ||
| them manually | ||
|
| ||
| Key lock is | Turn off the key lock. | |
The keypad | activated. |
| |
does not work | The scanner may | Turn the scanner off and | |
| be locked up. | then on again. | |
|
|
| |
The scanner is | SQ is not correctly | Adjust SQ by turning it | |
on but will not | adjusted | clockwise. | |
scan. | Only one channel is | Store frequencies into | |
| |||
| (or no channels | more than one channel | |
| are) stored. |
| |
|
|
|
71