Items for Specifying Scan Settings
Setting procedure of custom size when scanning part of an original
This section explains how to set a custom size for scanning an area within an original.
To scan a section of an original, measure Original Size (X1 and Y1), Start Position (X2 and Y2), and Scan Area (X3 and Y3) on the surface of the original, and then enter those values in the same order. Measuring methods differ depending on the original’s orientation and the position it is set in. Examples 1 to 3 below show how to measure the size in order to scan the section marked “R”. Refer to the following examples to measure each size correctly.
❖Example 1
Original is placed in the 
orientation on the exposure glass or in the ADF
6
ARE002S
❖Example 2
Original is placed in the 
orientation on the exposure glass
ARE003S
105