Ricoh AP306D operating instructions Low Memory

Appendix

Low Memory

The error message shown below is output by the printer whenever there is not enough memory to print your data.

There is not enough memory in your printer to print this page.

Change print quality in the printer driver and try again.

For details, please refer to the troubleshooting section in your manual.

The following are the actions you should take when you encounter memory shortage problems. If these actions do not solve the problem individually, try them in combination with each other.

AIncrease printer memory.

Install the optional memory unit to increase the amount of printer memory .

Reference

For more information about how to install the optional memory unit, see the "Setup Guide" that comes with the printer.

For more information about kinds of optional memory unit, see P.123 “Op- tions”.

6	B Change the color level settings.
	With the IPDL-C printer driver, the item to be changed differs from depend-

ing on the current setting on the [Print Quality] tab.

•If you use [Document Type], change the setting of [Printing Mode] to [Fast].

•If you use [Custom], change the setting of [Resolution:] on the [Quality Setting] tab to [600 dpi / Fast].

Reference

⇒The printer driver's Help

With the RICOH-SCRIPT2 printer driver, change the setting of [Gradation] on the [Device Options] tab.

•If you select [Standard], change the setting to [Fast].

•If you select [Fast], you cannot solve this problem in this setting.

Reference

⇒"Operating Instructions” for RICOH-SCRIPT2 included as a PDF file on the CD-ROM

118