Sending Scan Files to Folders

•In [Effective Protocol], enable [IPv4]

•To send files to shared folders, enable [SMB] in [Effective Protocol]. To send files to NetWare folders, enable [NetWare] in [Effective Protocol].

 

C If necessary, change settings in [Send Settings] under [Scanner Features].

 

Note

 

❒ To connect the machine to the network using an IEEE 1394 cable or wire-

2

less LAN (IEEE 802.11b), an extended 1394 board or extended wireless

LAN board is required respectively. For details, see Network Guide.

❒Items to set up in [System Settings] vary depending on the network environ- ment. For more information about network settings, see General Settings Guide.

❒For details about [Scanner Features], see General Settings Guide.

❒Sending files using SMB is available only under a NetBIOS over TCP/IP environment. Sending files using SMB is not available under a NetBEUI environment.

❒Even when settings made with the control panel, Web Image Monitor, Tel- net, or other methods do not permit the use of SMB and FTP, sending files is still possible.

Registering Destination Folders in the Address Book

You can register the addresses of frequently-used destination folders in the address book. Register the folder addresses in [Address Book Management] under [Administrator Tools] from [System Settings]. These addresses can also be registered as groups.

Note

❒For details about registering the address of a destination folder in the address book, see General Settings Guide.

❒You can register entries in the address book using Web Image Monitor or SmartDeviceMonitor for Admin. For details about installing SmartDevice- Monitor for Admin, see "Monitoring and Configuring the Printer", Network Guide. For details about registering addresses, see each application’s Help.

❒Depending on the machine type, you may not be able to use the machine when it is updating the address book using CSV files (retrieved using Smart- DeviceMonitor for Admin) that contain user codes.

40