
Sending Scan Files by
Preparation for Sending by
This section explains the preparation and settings for sending scan files by
1A Connect the machine to the network.
Connect the machine to the network using an Ethernet cable or wireless LAN (IEEE 802.11b).
B Make the necessary network setting in [System Settings].
If you have connected the machine to the network using an Ethernet cable, make the following settings. For details, see General Settings Guide.
•Specify the machine’s IPv4 address and subnet mask.
•Specify the IPv4 gateway address.
•In [Effective Protocol], enable [IPv4].
•Specify the SMTP server.
C If necessary, change settings in [Send Settings] under [Scanner Features].
Note
❒This machine does not support SMTPS (SMTP over SSL).
❒To connect the machine to the network using a wireless LAN (IEEE 802.11b), an extended wireless LAN board is required respectively. For de- tails, see Network Guide.
❒Items to set up in [System Settings] vary depending on the network environment. For more information about network settings, see General Settings Guide.
❒For more information about [Scanner Features], see General Settings Guide.
Registering
You can register frequently used
Register
Note
❒For details about registering
❒You can also register
❒Depending on the machine type, you may not be able to use the machine when it is updating the address book using CSV files (retrieved using Smart- DeviceMonitor for Admin) that contain user codes.
14