Roland MC-909 owner manual Sample Parameters, About the Loop Mode, 116

Sample Edit

Sample Parameters

Here you can make various settings for the sample.

1.In the Sample Edit screen, press [F2 (Sample Param)].

2.Use [CURSOR (up/down)] to select a parameter.

3.Use [VALUE] or [INC/DEC] to edit the value.

4.Press [F6 (Close)] when you are finished.

Parameter	Values	Explanation
Loop Mode	FWD,	How the sample will be played
	ONE-SHOT,	Refer to “About the Loop
	REV,	Mode” (p. 116)
	REV-ONE
Loop Tune	-50– +50	Pitch of the loop region
		Make fine adjustments in
		one-cent (1/100 semitone) in-
		crements.
Original Key	24 (C1)–	Note number that will play the
	127 (G9)	sample at the pitch at which it
		was sampled
BPM	5–300	Original BPM of the sample
		* You will need to edit this val-
		ue when using Auto Sync.
Time Stretch	TYPE01–	Auto sync method
Type	TYPE10	Decreasing this value will op-
		timize the sound for more
		rapid phrases, and increasing
		this value will optimize the
		sound for slower phrases.
Start Fine	0–255	Fine adjustment of the Start
		point.
Loop Start	0–255	Fine adjustment of the Loop
Fine		Start point.
Loop End	0–255	Fine adjustment of the End
Fine		point.

About the Loop Mode

FWD (Forward)

After the Sample played back from the Start point to the End point, it will then be repeatedly played back in the forward direction, from the Loop Start point to the End point.

	Loop
Start	Start P.	End P.

ONE-SHOT

The sample will be played back only once, from the Start point to the End point.

	Loop
Start	Start P.	End P.

REV (Reverse)

When the sample has been played back from the End point to the Start point, it will be repeatedly played back in the reverse direction, from the Loop Start point to the Start point.

	Loop
Start	Start P.	End P.

REV-ONE (Reverse One-shot)

The sample will be played back only once from the End point to the Start point in the reverse direction.

	Loop
Start	Start P.	End P.

116