154
Chapter 9 Parameter Guide MASTER
EXP PEDAL (Expression Pedal)
Parameter/
Range Explanation
SW (Switch)
OFF, ON This setting determines whether control us-
ing an expression pedal connected to the
EXP PEDAL jack is switched on or off.
TARGET PARAMETER
This selects the parameter to be changed.
Refer to
“TARGET PARAMETER”
(p. 157).
MIN (Minimum)
This sets the minimum value for the range in which the parameter
can change.
The value differs depending on the parameter assigned for TARGET
PARAMETER.
MAX (Maximum)
This sets the minimum value for the range in which the parameter
can change.
The value differs depending on the parameter assigned for TARGET
PARAMETER.
RANGE LOW, RANGE HIGH
Low: 0–126
High: 1–127
You can set the range for control of target
parameters within an expression pedal’s
response range. Target parameters are
controlled within the range set with
RANGE LOW and RANGE HIGH. You
should normally set RANGE LOW to 0 and
RANGE HIGH to 127.
CTL3, CTL4 (Control3, Control4)
Parameter/
Range Explanation
SW (Switch)
OFF, ON This setting determines whether control us-
ing a footswitch connected to the CTL3,
CTL4 jack is switched on or off.
TARGET PARAMETER
This selects the parameter to be changed.
Refer to
“TARGET PARAMETER”
(p. 157).
MIN (Minimum)
This sets the minimum value for the range in which the parameter
can change.
The value differs depending on the parameter assigned for TARGET
PARAMETER.
MAX (Maximum)
This sets the minimum value for the range in which the parameter
can change.
The value differs depending on the parameter assigned for TARGET
PARAMETER.
SW MODE (Switch Mode)
This sets the behavior of the value each time the switch is operated.
MOMENT The setting is normally OFF (minimum val-
ue), switching to ON (maximum value)
while the footswitch is held down.
LATCH The setting alternately switches to OFF
(minimum value) and ON (maximum val-
ue) each time the footswitch is pressed.
VG-99_e.book 154 ページ ２００７年７月５日　木曜日　午前９時２２分