52

Chapter 5 Using the VG-99 in Combination with an FC-300

With an FC-300 (optional) connected to the VG-99, you can perform
the following operations:
Switch patches
Have patch names be shown in the FC-300’s display
Control tones with the FC-300’s pedals (Control Assign)
Show the VG-99’s tuner in the FC-300’s display when the
TUNER function is used
Switch the FC-300’s Amp Control on and off
Connect the VG-99 and FC-300 using the RRC2 cable included with
the unit.

What is RRC2?

RRC2 is a Roland protocol that provides for the supply of
power and two-way data communications over a single cable.
Devices can also be connected using a commercially available
ethernet cable instead of the included RRC2 cable.

Be sure to connect the RRC2 OUT connector to a device with an
RRC2 IN connector. Use of the connection with LAN or other
devices may cause generation of heat and damage to the
equipment.
Carefully connect the RRC2 cable the way in—until it is firmly
to the RRC2 IN connector.
Do not subject the RRC2 cable to stress or physical shock.
If using commercially available ethernet cable as the RRC2
connecting cable, be sure that the cable meets the following
specifications:
Category 5 (Cat5) or above
Maximum length of 15 meters
Cable designed for straight-through connection.
* Ethernet cables designed for crossover connections cannot be used.
If connecting the VG-99 with an FC-300 using an RRC2 cable, make
the settings below as needed.
This sets the method for controlling the FC-300.

1.

Press [SYSTEM].

2.

Press PAGE [ ] to display Page 1.

3.

Press [F5] (FC-300).

4.

Set the SYS EX MODE with [F1] (OFF/ON) or
with the F1 knob.

Connecting with the RRC2

IN Connector

Settings Related to the FC-

300

Settings for Control of the FC-

300

Available
Settings
Description

ON
When connected to the VG-99, the FC-300 automat-
ically changes to Exclusive mode and functions in
accordance with the settings made with the VG-99.
This is the setting normally selected. You can con-
trol the FC-300 even without matching the VG-99’s
and FC-300’s Device IDs.
Connecting an FC-300 automatically switches the
FC-300 to Exclusive mode. Normally, you should
select this setting.
OFF
Select OFF when using the FC-300 in a mode other
than System Exclusive mode.
The mode does not switch automatically.
VG-99_e.book 52 ページ 2007年7月5日 木曜日 午前9時22分