98
Chapter 8 Other Functions
You can use the VG-99 while attached to a PDS-10 stand (optional).
1.
Turn the VG-99 over and remove the screws
from the bottom panel.
2.
Attach the mounting plate as shown in the
figure, using the screws removed in Step 1 or
the knob nuts included with the kit.
3.
Attach the VG-99 to the stand.
For instructions on how to assemble the PDS-10 and
attach the mounting plate, refer to the Owner’s Manual
that came with the PDS-10.
Using the VG-99 on a Stand
928, 929
• To prevent the PDS-10 stand from falling, use the attached
cable ties to wind all cables around the stand, as shown in
the figure below.
• Use the screws (M5 x 10) included with the VG-99 to
attach the PDS-10 mounting plate. Use of other screws
may damage the device internally or cause the unit to be
inadequately secured.
• When turning the unit over, place some newspapers,
magazines, or other such material under the four corners
or at both ends to prevent damage to the buttons, dials,
and other controls. Also, try to orient the unit so no
buttons or controls are damaged.
• When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
• When removing the screws, be sure to keep them out of
the reach of children to prevent smaller children from
accidentally swallowing them.
• Take care not to allow hands and fingers to become
pinched when attaching and removing the units.
Cable tie
VG-99_e.book 98 ページ ２００７年７月５日　木曜日　午前９時２２分