This defines the Controller ID for this system. The default is 1 but when multiple controllers are used, each additional controller ID must be sequential and unique and be set before being connect- ed to the system. Note that the system must be restarted before the controller will assume the new ID.
WARNING: This procedure returns the controller to its original settings - use with discretion.
Factory Initialization allows the installer to erase all programmed settings and returns the settings to the factory default settings. All settings including source equipment IR commands will need to be reentered. An “Are you sure?” prompt and a “no” response allows the installer to cancel the reset; a “yes” at the prompt will load factory/default settings.

 

 

INSTALLER

 

 

INSTALLATION MENU

 

 

Zone Setup (cont’d)

5.

PAGE ENABLE -

This feature is either disabled or enabled. It allows the option of

 

(PagEn)

receiving or blocking a page in a zone. If disabled, the page will

 

 

not be sent to the zone. If enabled (default), the page will be

 

 

sent to the zone.

6.

PAGE VOLUME -

This feature allows the installer to adjust the Page Volume for the

 

(PagVl)

zone, from 0 (min) to 100 (max).

CTRLR SETUP (CtlId)

Controller Setup is the basic configuration of the controller. This setup menu selects the options for Controller ID and Factory Initialization. See Installation Menu on Page 50 and Controller Setup -

Flow Chart on page 68

1. CONTROLLER ID - (CtlId)

2. FACTORY INIT - (FInit)

POWER MGT (PwMgt)

The CAV6.6 is capable of managing the power state of the connected source equipment. The power management is configured on a source-by-source basis.

All sources that have power management enabled are initialized by a “POWER ON” command or macro which must cause the source to produce an audio signal. Power management is initialized when the first keypad is turned on or when the home theater trigger input has 12VDC present. The 12VDC trigger output is turned on when the first zone is turned on.

All sources that have power management enabled are turned off by the “POWER OFF” command after all zones have been turned off, with a timeout of five minutes.The 12VDC trigger output is turned off

57

Page 57
Image 57
Russound CAV6.6 Six-Zone instruction manual Zone Setup cont’d, Enable, Volume, Controller ID CtlId Factory Init FInit