CAT-5 Connection

The UNO-S2 Keypad uses a 110-punchdown terminal to provide a simple installation and strong connection for CAT-5 cable’s eight con- ductors. Punchdown terminals require the use of a punchdown tool which has been provided with the keypad kit. Attach the CAT-5 cable to the 110 punchdown terminal on the UNO-S2 Keypad as shown, matching the conductor colors to the connection color guide. The keypad will not operate properly if the terminations deviate from the required connection order.

Caution:

Take care when using an impact 110 punchdown tool, as this may overspread the contact points.

INSTALLER

UNO-S2 KEYPAD-INSTALLATION

UNO-S2 Keypad Connections

Use of the impact tool may propel stray bits of wire and jacket into the keypad’s chassis and possibly cause a short in the circuitry. Gently shake or blow air through the keypad chassis to remove stray wire before the keypad is installed into the junction box.

Jumper Setting

The jumper settings on the back of the UNO-S2 Keypad can be set for “Run” and “OS Update.” The jumper setting must be in the “Run” position before the keypad is mounted into the junction box, and must remain set in “Run” to operate the keypad. The jumper will be set to “OS Update” only while updating the keypad’s operating systems.

Punchdown Tool

Jumper Setting (back of keypad)

Punchdown Tool

CAT-5 Connections (back of keypad)

25

Page 25
Image 25
Russound CAV6.6 Six-Zone UNO-S2 KEYPAD-INSTALLATION, UNO-S2 Keypad Connections, CAT-5 Connection, Jumper Setting