INSTALLER
INSTALLATION MENU
Key Config (cont’d.)
2.SOURCE NUM – (Src #)
3.SELECT A KEY – (SelKy)
4.KEY TYPE – (KeyTp)
5.KEY NAME – (KeyNm)
6.COMMAND TYPE – (CmdTp)
a.Selected: Learned IR – (LrnIR)
i.LEARNED SRC – (LnSrc)
b.Selected: Unassigned (Unasg)
c.Selected: Default (Deflt)
d.Selected: Macro:
i.MACRO - (Macro)
ii.MACRO ID –
(MacID)
e. All Other Selections:
7.DEVICE CODE – (DevCd)
8.KEY FUNCTION – (KeyFn)
9.SAVE CHANGES? – (Save?)
Select the source the key will be configured for.
Using 
or 
, select the keypad key to be configured.
Either “Key Press,” “Key Hold” or “Both” will activate the command.
Name that appears on the keypad display when the command is activated.
Select the type of source command (e.g., CD, TV, etc.).
Choose Learned IR if the
Select the learned source bank to be assigned to the source component. Procedure advances to KEY FUNCTION (step 8)
The key configuration is cleared. Procedure advances to SAVE CHANGES (step 9)
Default selects the same device type and device code previously setup in BASIC SETUP. Procedure advances to KEY FUNCTION (step 8)
(To build macros, see Macro Editor page 60)
Macro loads a series of commands which are processed when activated.
Enter the macro ID number. Menu advances to SAVE CHANGES (step 9)
Procedure advances to DEVICE CODE (step 7)
Enter source component code number listed in this manual’s Reference section.
Select a function for the button.
Select “yes” to save changes. Procedure advances to ZONE NUM (step 1)
52
