CHANGING THE SIZE OF THE PAPER IN THE PAPER TRAY
To load longer sizes of paper, such as
1 Tray extend lever
2 Paper length guide
3 Paper width guide
1.Adjust the paper length guide to the desired paper length. It is preset to Letter or A4 size depending on the country.
2.After inserting paper into the tray, while pinching the paper width guide as shown, move it toward the stack of paper until it lightly touches the side of the stack. Do not press the guide too tightly to the edge of the paper; the guide may bend the paper.
When you use
3.Press and hold the green lever on the back of the tray, when you are holding the lever, extend the tray to the corresponding position.
4.Load the paper into the tray.
5.Place the tray into the machine.
6.Set the paper size from your computer.
• Do not push the paper width guides far enough to cause the materials to warp.
•If you do not adjust the paper width guides, it may cause paper jams.
LOADING PAPER
Loading paper in the tray 1 or optional tray
Load the print media you use for the majority of your print jobs in the tray 1.
The tray 1 can hold a maximum of 250 sheets of 75 g/m2 (20 lb bond) plain paper.
You can purchase an optional tray and attach it below the standard tray to load an additional 500 sheets of paper. (See "" on page 91.)
Using photographic paper or coated paper may cause problems, requiring repairs. Such repairs are not covered by Samsung’s warranty or service agreements.
1.To load paper, pull and open the paper tray and place paper with the side you want to print facing up.
1 | Full |
2 | Empty |
2.After loading paper, set the paper type and size for the tray 1. See Software section for
• If you experience problems with paper feed, place one sheet at a time in the
•You can load previously printed paper. The printed side should be facing down with an uncurled edge at the front. If you experience problems with paper feed, turn the paper around. Note that print quality is not guaranteed.
