Installing your dryer
CONNECTING THE INLET HOSE
Method 1
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.
1.If space permits, attach the brass female end of the “Y” connector to the cold water faucet.
2.Turn the cold water faucet off.
3.Attach the straight end of long hose to the “Y’ connector.
4.Using pliers, tighten the coupling with an additional two- thirds turn.
Do not overtighten, as this may damage the coupling.
5.Attach the angled end of long hoses to fi ll the valve at the bottom of the dryer’s rear frame. Screw on the coupling by hand until it is seated on the fi ll valve connector.
6.Using the pliers, tighten the coupling with an additional two- thirds turn.
Do not overtighten, as this may damage the coupling.
7.Check that the water faucets are on.
8.Check for leaks around the “Y” connector, faucets and hoses.
Water Hose 
Duct Exhaust
Frame (back)
Water Hose
English - 18
