Method 2
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.
1.If the “Y” connector cannot be attached directly to the cold water faucet, the short hose must be used.
2.Turn the cold water faucet off.
3.Attach the short inlet hose to the cold water faucet. Screw on the coupling by hand until it is seated on the faucet.
4.Using the pliers, tighten the coupling with an additional two- thirds turn.
Do not overtighten, as this may damage the coupling.
5.Attach the ‘Y” connector to the brass male end of the small hose. Screw on the coupling by hand until it is seated on the connector.
6.Using the pliers, tighten the coupling with an additional two- thirds turn.
Do not overtighten, as this may damage the coupling.
7.Attach the angled end of long hoses to the fi ll valve at the bottom of the dryer rear frame. Screw on the coupling by hand until it is seated on the fi ll valve connector.
8.Using pliers, tighten the coupling with an additional two- thirds turn.
Do not overtighten, as this may damage the coupling.
9.Check that the water faucets are on.
10.Check for leaks around the “Y” connector, faucets and hoses.
Short hose (Inlet to cold water)
“Y” connector
Long hose
Duct Exhaust
Frame (back)
Water Hose
02 INSTALLING YOUR DRYER
English - 19
