How to assemble the Wall Mount Bracket
Insert and tighten the Captive Screw in the direction of the arrow.
1 When done, mount the wall bracket on the wall.
Captive Screw
Wall Bracket
Hinge (Left)
There are two hinges (left and right). Use the
correct one.
Hinge (Right)
Before drilling into the wall, check if the
2 length between the two locking holes at the back of the product is correct. If the length is too short or long, loosen all or some of the 4 screws on the wall bracket to adjust the length.
Length between the two locking holes
Check the installation diagram and
3 mark the drill points on the wall.
Use the 5.0 mm bit to drill holes deeper than 35 mm. Fix each anchor in the corresponding hole. Match each of the brackets and hinge holes to the corresponding anchor holes and insert and tighten the 11 screws 
.
16
