DIGITAL VIDEO RECORDER
6System Setup
The following illustrates the intial setting of the SYSTEM SETUP menu.
SYSTEM SETUP
PASSWORD | **** |
PASSWORD LOCK | OFF |
HDD ERASE | OFF |
FACTORY RESET | OFF |
MENU SCREEN | DARK GRAY |
LANGUAGE | ENGLISH |
IR REMOCON | OFF |
MULTIPLEXER | WITHOUT |
MULTIPLEXER SELECT | SAMSUNG |
MOVE=[ /❷/➛/❿] SELECT=[ | ] EXIT=[MENU] |
①PASSWORD
Set the system password. You can enter a
If you set this to ON, the system will ask for a password, which was set in PASSWORD,
MENU
when your press the MENU ( ) button or when you attempt to cancel the recording lock while recording or when you attempt to remove the video tape from the video deck. If the password is invalid, you will not be able to finish the desired operation. If you set this to OFF, the system will not ask for a password for any of the operations above.[ON/OFF]
➂HDD ERASEIf you set to ON and exit the menu, the system will delete all data stored on the HDD.
[ON/OFF]
Caution
Verify once again that is is OK to delete the data, as deleted data cannot be restored.
➃FACTORY RESETIf you set to ON and finish the menu, all settings will be restored to their factory default set- tings. However, the data on the HDD will not be deleted. After RESET The message, “DO YOU REBOOT SYSTEM?” will be displayed. Select YES to reboot the system. [ON/OFF]
➄MENU SCREENIf this is set to DARK GRAY, the background of the screen becomes darker when the MENU button is pressed and you will not be able to see the characters clearly. If set to OFF, you can see the current video clearly even when the MENU button is pressed.
[DARK GRAY/OFF]There is a language support setting function for the convenience of international users. The default language is set to English.
●
●
If IR REMOCON to ON, signals from the remote control will be received and if it is set to OFF, signals from the remote control will not be received. The option will be turned off by factory default reset. For instructions on how to use the remote control, please refer to “4.
Introduction to the Remote Control” on page
⑧MULTIPLEXER
If MULTIPLEXER is set to WITHOUT, ID Detection will not be performed and the system will recognize it as 1CH regardless. If MULTIPLEXER is set to WITH, the Video ID input from the Multiplexer will be detected. Set MULTIPLEXER to WITH, and exit the MAIN MENU (DVR) to automatically start the Multiplexer ID Detection. In addition, MULTI- PLEXER SELECT will be enabled and MOTION
If MULTIPLEXER is set to WITH, MULTIPLEXER SELECT will be enabled. The settings of all recording modes will be dependent on the Multiplexer setting.
The corresponding Multiplexers are SAMSUNG
●
Caution
Do not set the multiplexer option to [With] and fail to receive the multiplexer output signal as input to avoid error in recording. Please set the multiplexer option to [Without] whenile not receiving the multiplexer output signal as input.
Set the multiplexer option to [Without] unlessif the multiplexer manufacturer of the multiplexer is not Samsung.