DIGITAL VIDEO RECORDER
4ARCHIVE SETUP
The following illustration shows the initial settings of the ARCHIVE SETUP menu.
ARCHIVE SETUP
TAPE REC IF HDD TROUBLE EMG [O]
|
|
| FULL[X] | |
VCR SPEED |
| SP |
| |
TAPE SELECT | ||||
VCR BUZZER | OFF |
| ||
CHANNEL |
| SELECT | ||
CH 1:ON | CH 5:ON | CH 9:ON | CH13:ON | |
CH 2:ON | CH 6:ON | CH10:ON | CH14:ON | |
CH 3:ON | CH 7:ON | CH11:ON | CH15:ON | |
CH 4:ON | CH 8:ON | CH12:ON | CH16:ON | |
|
|
|
|
|
MOVE=[ /❷] SELECT=[ | ] EXIT=[MENU] |
1)EMG
Set whether to allow the VCR to continue the recording if the hard drive fails for some rea- son. If there is a problem in HDD, it will automatically execute VCR BACKUP. If you replace the failed hard drive with a new one, VCR backup will be cancelled and the system will to the previous state, before the failure occurred. [O/X]
2)FULL
Set whether to allow the VCR to continue the recording if DISK END MODE is set to STOP. However, if DISK END MODE is set to OVERWRITE, this will be disabled. [O/X]
(2) VCR SPEEDSet the recording mode for the VCR. If you set this to SP, recording time will be shorter but picture quality will be better than setting it to SLP; and if you set this to SLP, recording time will be longer but picture quality will be poorer than setting it to SP.
●
●
Note
- Recording Time to Recording Mode
| SP | SLP |
2 Hours | 6 Hours | |
|
|
|
| SP | LP |
3 Hours | 6 Hours |
Set the tape length for accurate calculation of remaining tape time and precise control.
●
●
Set the buzzer so that the VCR's status could be known. If there is a problem in VCR SYS- TEM Set it to ON to enable the BUZZER and to OFF to disable the BUZZER.
The buzzer will sound in the following cases.: - If there is a problem in the VCR SYSTEM.
- If the tape reaches the end part or is in PRE END (when the remaining time is less than 5 minutes) during ARCHIVE.
- If there is no tape inserted, or REC Safety TAB is removed from the inserted tape when you start ARCHIVE, or in TIMER ARCHIVE MODE. [ON/OFF]
(5)CHANNELCHANNEL is enabled if MULTIPLEXER is set to WITH and disabled if it is set to WITH- OUT. If CHANNEL is enabled and you set it to SELECT, all channels recorded on the hard drive will be displayed. If you set it to ALL, all channels will be set to ON and become tar- gets for backup. [SELECT/ALL]