Samsung manual Specification, SPR-7416 Model

Appendix

<SPR-7416 Model>

[Display Board]

External monitor

	ON OFF
External monitor output	1 2 3
Control switch	4

ON OFF

1 2 3 4

ON OFF

1 2 3 4

The distance between the DVR and external monitor should be measured then you can change the control switch on the back of the DVR accordingly. There are 4 level settings for the difference distances between DVR and Monitor so you can select which gives the best picture.

1For 100 meter distance select dip switch setting one.

2For 200 meter distance select dip switch setting two.

3For 300 meter distance select dip switch setting three.

4For 400 meter distance select dip switch setting four.

[Warning]

The set-up must be with only one switch turned on at a time. If the all switches are turned off there is no signal output to the external monitor.

[Notice]

If the distance is 500m or if the installation environment is not good then the picture display quality will be reduced.

The distance between 100~400 have been tested but the actual distance can be changed depending on weather and line condition.

[Notice]

For the SPR-7116 Model, the external monitor connector on IO board is not operational, The external monitor connector on display board must be used.

5-11

Specification