Using the ShowView Feature

Before presetting your DVD-VCR:

Switch on both the television and your DVD-VCR

Check that the date and time are correct

Insert the cassette on which the programme is to be recorded (safety tab intact)

Up to six programmes can be preset.

1To enter a ShowView, press the TIMER button.

Press the orand OK or buttons to select

ShowView

Result: A message is displayed to allow you to enter the ShowView code.

If all six programmes have been set, the message Timer is full is displayed. Refer to page 24 if you wish to cancel a preset recording.

Timer Method

Standard

ShowView

ShowView

Code

 

Code

: 0 - 9

 

Correct

:

 

 

 

 

 

 

 

 

 

2Press the numeric buttons to enter the code opposite the programme that you wish to record in your television magazine.

If you wish to correct the ShowView code that you are entering:

Press the button until the digit to be corrected is cleared

Enter the correct digit

3Press the OK button.

Result: The information concerning the programme is displayed.

When using the ShowView function for the first time with stored stations, the programme number flashes. This one time, you must enter the station number manually by pressing the

orbuttons. Refer to the following page if:

The programme number or times flash

You wish to modify the programme

4If the programme and times are correct, press the RETURN button.

5Press the STANDBY/ON button to activate the timer.

6Refer to page 21~22 if you wish to:

Check that your DVD-VCR has been programmed correctly

Cancel a preset recording

The numbers next to each TV programme listing are ShowView code numbers, which allow you to programme your videorecorder instantly with the remote control. Tap in the ShowView code for the programme you wish to record.

ShowView is a trademark of Gemstar Development Corporation. The ShowView system is manufactured under licence from Gemstar Development Corporation.

ENG-19

Page 20
Image 20
Samsung SV-DVD640 Using the ShowView Feature, Before presetting your DVD-VCR, Check that the date and time are correct