Sanyo HF15000L Connecting the AC Power Cord, Projector side, AC Outlet side, Installation

Installation

Connecting the AC Power Cord

This projector uses nominal input voltages of 200-240 V AC. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system.

If you are not sure of the type of power being supplied, consult your authorized dealer or service center.

Connect the projector with all peripheral equipment before turning on the projector.

A power cord clamp is designed to prevent the AC power cord from coming loose. Attach the power cord clamp and AC power cord to the projector by following these steps.

1	Insert the both ends of the power cord clamp into the
	holes and tilt the clamp.
2	Connect the AC power cord to the projector.
3	Secure the power cord connector with the clamp.

Holes

1

Power cord clamp

2

CAUTION 3

The AC outlet must be near this equipment and must be easily accessible.

✔Note:

•Unplug the AC power cord or turn off the MAIN ON/OFF Switch when the projector is not in use. When the projector is in stand-by mode, it consumes a little electric power.

NOTE ON THE POWER CORD

AC power cord must meet the requirements of the country where you use the projector. Confirm the AC plug type with the chart below and proper AC power cord must be used. If the supplied AC power cord does not match your AC outlet, contact your sales dealer.

Projector side	AC Outlet side
For the U.S.A. and Canada	For Continental Europe	For the U.K.
Ground		Ground

To POWER CORD
CONNECTOR on your	To the AC Outlet.	To the AC Outlet.	To the AC Outlet.
projector.	(200-240 V AC)	(200–240 V AC)	(200–240 V AC)

23