Settings
RC sensor
Select a location of the infrared remote receiver of the remote control. See “Remote Control Receivers and Operating Range” on page 15 for details.
All | Activates all of the receivers |
Front & Top | Activates both the front and top receivers |
Top & Back | Activates both the top and back receivers |
Front & Back.... | Activates both the front and back receivers |
Front | Activates only the front receiver. |
Top | Activates only the top receiver |
Back | Activates only the back receiver. |
✔Note
•When placing the projector in the horizontal position, as fluorescent light may negatively affect the remote control signals, it is recommended to select either “Back” or “Front” to prevent the receiver on top of the projector from picking up the signals from the remote control.
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready | When the lamp has been fully cooled |
| down, the POWER indicator changes |
| to green blinking. In this condition, the |
| projection lamp will be turned on if the |
| input signal is reconnected or any button |
| on the side control or remote control is |
| pressed. |
Shut down | When the lamp has been fully cooled |
| down, the power will be turned off. |
Off | Power management function is off. |
Timer | If the input signal is interrupted and |
| no button is pressed for more than 30 |
| seconds, the timer display with No signal |
| appears. It starts the countdown until |
| the lamp is turned off. Use the Point ed |
| buttons to set the Timer(1~30Min). |
✔Note
•Factory default is Ready: 5 Min.
•When the shutter is closed while the Power management function is working, the Power management function is released.
No signal
4 : 50
Timer left before Lamp is off.
Direct on
When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to the wall outlet.
✔Note
•Be sure to turn off the projector properly (see “Turning Off the Projector” on page 25). If the projector is turned off in the incorrect sequence, the "Direct on" function does not work properly.
63
