28
Press the Point edbuttons to select the Image adj. Menu
and press the Point 8or OK buttons to access the submenu
items.
1
2Use the Point edbuttons to select the desired item and
press the Point 8or OK buttons to access the selected item.
The adjustment bar is displayed. Image adj. Menu
Press the Point 7button to decrease the contrast; press the Point
8button to increase the contrast (from -31 to +31).
Press the Point 7button to decrease the brightness; press the
Point 8button to increase the brightness (from -31 to +31).
Contrast
Brightness
Press the Point 7button to decrease the intensity of the color;
press the Point 8button to increase the intensity of the color
(from -31 to +31).
Use the Point 7 8buttons to adjust the tint value to obtain a
proper color balance (from -31 to +31).
Color
Tint
Image Mode Adjustment
Use the Point 7 8buttons to select the desired Color temp. level
(High, Mid, Low1, Low2, or Low3).
Color temp.
IMAGE ADJ.
MENU
RESET
OK
IMAGE
SCREEN
BRIGHT
BRIGHTNESS CONTRAST
COLOR
CONT.
IMAGE ADJ. button
Direct Operation
Press the IMAGE ADJ. button on the remote control to display the
adjustment bar of Image adj. Menu items one at a time and directly
adjust the selected item.
Use the Point edbuttons to select the desired item and the Point
7 8buttons to adjust the setting. Press the MENU button after
adjusting.
If you press the OK button after adjusting each item, it will enter
the main menu.
Menu Operation
Remote Control
The selected item.
Use the Point 7 8buttons
to adjust the setting
values and press the OK
button.
If you press the Point d
button, the next item can
be selected.
Press the Point 8or OK
buttons to access the
selected item. The adjust-
ment bar is displayed.
3Use the Point 7 8buttons to adjust the setting values and
press the OK button.
Brightness ➜Contrast ➜Color ➜Tint ➜Color
temp. ➜Red ➜Green ➜Blue ➜Sharpness ➜
Lamp control ➜Gamma ➜Progressive ➜Lens
iris ➜Lamp iris ➜Auto black stretch➜Contrast
enhancement ➜Transient improvement ➜Gain
R/G/B ➜Offset R/G/B ➜Gamma R/G/B ➜
Brightness ➜ • • • •
Image mode can be adjusted for each input source and the adjustment is kept until the projector is turned off or the image
mode is changed.
✔Notes:
•Tint cannot be selected when the video system is PAL, SECAM, PAL-M, or PAL-N
except for 575i.
•The Image adj. Menu cannot be operated without an input signal.
Go on to the next page....
Image Adjustment